Roof Trusses Reiforcement

Truss design drawings shall include the following information.

Roof trusses reiforcement.

Without bracing it is almost impossible to install trusses. Trusses form the roof line on buildings and provide support for the lumber that holds shingles or other form of roof cover. These are usually accomplished during a complete re roofing. However if you want to better utilize the space in your loft you may consider changing roof trusses and going for stick framing or rafters instead.

The trusses needed to be lifted to their original height and cut flush with the inside face of the cmu wall with the rotted sections removed. Bracing for putting up trusses. O slope or depth span and spacing o location of all joints. Some bracing provides a way to put up the trusses evenly while holding them and other bracing supports them after they are put up.

Truss design drawings shall be provided to the building official and approved prior to installation r802 10 1. The first step to reinforcing the roof is to add an x to the frame. Remember any alterations to a roof should be undertaken only with an engineer. Roof trusses are a common means of support and load bearing.

To reinforce the ends of the trusses 3 4 inch plywood gussets were to be attached to both sides of each truss with 10d nails 3 inches on center on all chords. Reinforce your roof a properly constructed roof in areas subject to high winds has trusses attached to walls with hurricane tiedowns properly nailed sheathing and heavy duty shingles. Consult your local code officials for details. If you don t have an a frame roof you can run parallel boards between the studs to further offer support and to strengthen the frame.